KSSTA - 2026-10-07 - Journal Article
Preoperative varus ≥10° does not compromise outcome after medial unicompartmental knee arthroplasty, whereas postoperative joint-line convergence angle and insert thickness influence functional results: A matched-pair analysis.
Weishorn J, Bonnmann S, Trefzer R, Hariri M, Mick P, Lunz A, Walker T, Koch KA
Topics
Key Takeaway
Medial UKA in knees with preoperative varus ≥10° achieves 10-year revision-free survival of 92.3% and OKS of 40.6, equivalent to matched varus <10° controls, provided postoperative JLCA is maintained at 0°–5° varus and insert thickness remains <7 mm.
Summary Depth
Choose how much analysis to show on this article page.
Summary
This matched-pair retrospective study asked whether preoperative varus ≥10° compromises medial mobile-bearing UKA outcomes and which postoperative alignment parameters drive functional results. At mean 10.1 years, OKS (40.6 vs. 38.8) and 10-year revision-free survival (92.3% vs. 90.2%) were equivalent between high- and low-varus groups. In the ≥10° cohort, postoperative JLCA outside 0°–5° varus reduced PASS achievement from 70% to 33%, and insert thickness ≥7 mm reduced PASS from 81% to 30%.
Key Limitation
Retrospective matching cannot control for surgeon-level variability in soft-tissue balancing technique, which directly determines both JLCA and insert thickness selection—the two variables shown to drive outcomes.
Original Abstract
PURPOSE
To evaluate functional outcomes and implant survival following medial unicompartmental knee arthroplasty (UKA) in patients with anteromedial osteoarthritis and preoperative varus deformity ≥10° and to identify postoperative alignment thresholds that optimize outcomes.
METHODS
Patients with preoperative varus ≥10° who underwent medial mobile-bearing UKA were retrospectively analysed and matched 1:1 to knees with preoperative varus <10°, yielding 132 pairs (264 knees) with similar baseline characteristics. Primary outcomes were revision rates and the Oxford Knee Score (OKS). Full-length standing radiographs were used to measure the hip-knee-ankle angle (HKA), joint-line convergence angle (JLCA), extra-articular deformity (EAD), mechanical medial proximal tibial angle (mMPTA), mechanical lateral distal femoral angle (mLDFA) and joint-line obliquity (JLO) and determine functional knee phenotypes. Univariate curve-adjusted regression assessed the influence of alignment on OKS, and receiver operating characteristic (ROC) analysis defined the alignment range within which the Patient-Acceptable Symptomatic State (PASS) was achieved.
RESULTS
At a mean follow-up of 10.1 ± 3.3 years, OKS did not differ between groups (40.6 ± 8.0 vs. 38.8 ± 5.7, n.s.), nor did revision-free survival (92.3% vs. 90.2% at 10 years, p = 0.618). In knees with preoperative varus ≥10°, postoperative JLCA correlated with OKS (R 2 = 0.43, p < 0.001), whereas HKA, EAD, mMPTA, mLDFA and JLO showed no association (p > 0.05). JLCA outside 0°-5° varus yielded inferior OKS (35.6 ± 11.0 vs. 42.4 ± 6.2, p = 0.022) and lower PASS achievement (33% vs. 70%, p = 0.011). Insert thickness ≥7 mm was associated with lower OKS (32.1 ± 12.1 vs. 41.2 ± 5.9, p = 0.004) and reduced PASS (30% vs. 81%, p = 0.046).
CONCLUSIONS
Medial UKA in knees with preoperative varus deformity ≥10° achieved functional outcomes and implant survival comparable to matched knees with varus <10°, provided postoperative JLCA is restored to 0°-5° varus and excessive insert thickness is avoided. Intraoperative insert upsizing should prompt reassessment for ligamentous insufficiency or compartment overstuffing.
LEVEL OF EVIDENCE
Level III.